Raymarine St60 Wind Service Manual

Raymarine St60 Wind Vane
Raymarine St60 Manual

Download

This manual provides servicing information for the Raymarine short-arm and long-arm wind vanes, part numbers E22078 and E22079, respectively. The following information is provided:. Tools and test equipment. An exploded view of the wind vane. A list of replaceable parts. Disassembly and assembly instructions. Functional tests. ST60+ Wind The ST60+ Wind instrument provides a 360 ° apparent wind scale and can be used either as a stand-alone unit, or as part of an integrated SeaTalk instrumentation system. ST60 Wind instrument ST60 Close Hauled Wind instrument WIND ST60 + TR UE AP P VM G DIS P TA CK TRUE APP VMG DISP TACK CH WIND + 812641.book Page vii Monday. Now, new this year the wind speed only show 0.0. Wind direction is fine. I searched this forum, and performed the following troubleshooting at the terminal strip beneath the mast compression post: Red to shield should read 8 volts DC steady. This is the masthead power supply, coming from the ST50/ST60 display head. Manuals and documents for Raymarine product range. Raymarine Service and Support; Raymarine Manuals and Documents. CPT-120 RotaVecta Wind Transducer Rudder.

52 pages, 1.11 Mb

Success! {{ $ctrl.successMessage }}

0'>Errors!

viiiST60 Wind & Close Hauled Wind Instrument Owner’s Handbook

ST60 Close Hauled Wind

The ST60 Close Hauled Wind instrument provides an expanded indication from

-60° to +60° about the bow and stern of the boat, on a combined analog and

Data inputs

SeaTalk

Raymarine St60 Wind Vane

SeaTalk enables a number of compatible instruments to operate as a single,

integrated navigational system. Instruments in a SeaTalk system are linked by

means of a single cable, which feeds both power and data. Instruments can

therefore be added to the system by plugging them into the network. SeaTalk is

flexible enough to adapt to any number of compatible instruments without

requiring a central processor. SeaTalk can also communicate via an appropriate

interface with non-SeaTalk equipment , using the internati onally-accepted

National Marine Electronics Association (NMEA) protocol.

In a SeaTalk system, each instrument can be either a master or dedicated repeater

unit. A master instrument is directly connected to a transducer (the device that

provides the raw data), and provides data and control for the service it is

providing to all other equipment on the SeaTalk network. A slave instrument is

not directly connected to a transducer but repeats information provided by other

Stand alone operation

In Stand alone operation, the ST60 Wind instrument is connected only to the

relevant transducer and does not display information from, or provide

Raymarine St60 Manual

Note:

The ST60 Close Hauled Wind instrument operates only as a SeaTalk repeater. It ca n-

Remote control

When connected to SeaTalk, the ST60 Wind and Close Hauled Wind instruments

can be controlled remotely by a SeaTalk Remote Keypad Unit, to provide instant

Help required to diagnose problem with ST60 Close Hauled Wind Instrument.
Symptoms. Wind direction working properly. Wind speed showing zero. I've replaced PCB in masthead unit and these are my voltage readings to earth. Yellow (wind) 8V, spec is 0 to 5V. Other wires to spec. Disconnecting yellow from instrument head gives a very low masthead unit output voltage, circa 0.1V variable in 10Kn wind. The open circuit yellow on instrument is just over 8V.
I have swapped the master instrument head with the slave instrument and had identical results prior to replacing the masthead PCB. Is it possible that the original masthead unit blew both instrument heads prior to its replacement?